Cooper Lighting LUMARK Impact Wall Medium User Manual download pdf

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation,

operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.

NOTE: Specifications and dimensions subject to change without notice.

Impact Wall Medium

Door Accessories

Sheet 1 of 1

7/22/08 IMI-698

INSTALLATION INSTRUCTIONS

IMPORTANT : READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN FOR FUTURE REFERENCE

GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight

damage which should be brought to the attention of the delivery carrier.

Compare the catalog description listed on the packing slip with the

fixture label on the housing to assure you have received the correct

material.

SAFETY: This fixture must be wired in accordance with the National

Electrical Code and applicable local codes and ordinances. Proper

grounding is required to insure personal safety. Carefully observe

grounding procedure under installation section.

WARNING: Risk of Fire/Shock. If not qualified, consult an electrician.

Risk of Electric Shock. Disconnect power at fuse or circuit breaker

panel or fuse box before installing or servicing.

Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADH081510

NOTE: This instruction sheet is applicable for both Trapezoid and

Cylinder shapes. Cylinder shape is used for illustration.

VANDAL SHIELD ASSEMBLY:

1. Install four [4] shield tabs onto holes in the door with four [4]

10-24 X 3/8" screws. Do not tighten the screws all the way.

2. Insert four [4] 10-24 X 1 1/2" screws through the vandal shield

and the spacers as shown in FIG 1. Line up the screws with

spacer with shield tabs and tighten it securely. Repeat the

process with all four [4] screws.

3. Fully Tighten the four [4] tabs onto the door.

WIRE GUARD ASSEMBLY:

1. Line up the wire guard with four [4] holes in the door as shown

in FIG 2.

2. Insert four [4] 10-24 X 3/8" screws through the hooks in wire

guard. Tighten the screws until the wire guard is secured onto

the door.

Four (4)

Shield Tabs

Four (4)

1/4" Spacers

One (1)

Polycarbonate

Shield

Four (4)

10-24 X 1 1/2"

Phillips Pan Head

Stainless Steel Screws

Four (4)

10-24 X 3/8"

Phillips Pan Head

Stainless Steel Screws

FIG. 1

Four (4)

10-24 X 3/8"

Phillips Pan Head

Stainless Steel Screws

One (1)

Wire Guard

FIG. 2

INSTALLATION INSTRUCTIONS 1

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for me

Comments to this Manuals

No comments

Cooper Lighting LUMARK Impact Wall Medium User Manual

Browse online or download User Manual for Unknown Cooper Lighting LUMARK Impact Wall Medium. Cooper Lighting LUMARK Impact Wall Medium User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Cooper Lighting LUMARK Impact Wall Medium